125mm

The Time Saving Kit finishing sequence developed by AFS in partnership with Cibo is not only faster than traditional belt processes but also creates a higher quality finish than is normally achieved.

Step 1:  Remove the weld with the FX87GR 100 grit veramic discs on the soft foam faced back up pads

Step 2:  Refine the grinding lines with the 237GR Trizact discs (A65 followed by A45), ensuring that the sanding lines are in the direction of the final finish

Step 3:  Regrain the finish with the FMCM combination brush.

If you are re-enstating a mitre corner finish place a length of the Inoxitape on the surface where the joint is required and brush over the top with the FMCM combi brush.

125mm