The sequence developed by AFS in partnership with Cibo is not only faster than traditional belt processes but also creates a higher quality finish than is normally achieved. Step 1: Remove the weld with the FX87GR 100 grit veramic discs on the soft foam faced back up pads Step 2: Refine the grinding lines with the 237GR Trizact discs (A65 followed by A45), ensuring that the sanding lines are in the direction of the final finish Step 3: Regrain the finish with the FMCM combination brush. If you are re-enstating a mitre corner finish place a length of the Inoxitape on the surface where the joint is required and brush over the top with the FMCM combi brush. Alternatively, try our Time Saving Kit which is available in 125mm diameter.